fail-safe redundancy

См. также в других словарях:

• Redundancy (engineering) — In engineering, redundancy is the duplication of critical s of a system with the intention of increasing reliability of the system, usually in the case of a backup or fail safe. In many safety critical systems, such as fly by wire aircraft, some… …   Wikipedia

• Safety engineering — is an applied science strongly related to systems engineering and the subset System Safety Engineering. Safety engineering assures that a life critical system behaves as needed even when pieces fail.In the real world the term safety engineering… …   Wikipedia

• Autoland — In aviation, autoland describes a system that fully automates the landing phase of an aircraft s flight, with the human crew merely supervising the process.DescriptionAutoland systems were designed to make landing possible in visibility too poor… …   Wikipedia

• Life-critical system — A life critical system or safety critical system is a system whose failure or malfunction may result in: death or serious injury to people, or loss or severe damage to equipment or environmental harm. Risks of this sort are usually managed with… …   Wikipedia

• Damper (architecture) — A damper is a valve or plate that stops or regulates the flow of air inside a duct, chimney, VAV box, air handler, or other air handling equipment. A damper may be used to cut off central air conditioning (heating or cooling) to an unused room,… …   Wikipedia

• Damper (flow) — This article is about the architectural element. For other uers, see Damper (disambiguation). Opposed blade dampers in a mixing duct. A damper is a valve or plate that stops or regulates the flow of air inside a duct, chimney, VAV box, air… …   Wikipedia

• Fault-tolerant system — This article contains specific implementations of fault tolerant systems. For general theory, see fault tolerant design. Fault tolerance or graceful degradation is the property that enables a system (often computer based) to continue operating… …   Wikipedia

• Fault-tolerant design — In engineering, Fault tolerant design, also known as fail safe design, is a design that enables a system to continue operation, possibly at a reduced level (also known as graceful degradation), rather than failing completely, when some part of… …   Wikipedia

• Economic Affairs — ▪ 2006 Introduction In 2005 rising U.S. deficits, tight monetary policies, and higher oil prices triggered by hurricane damage in the Gulf of Mexico were moderating influences on the world economy and on U.S. stock markets, but some other… …   Universalium

• Brake-by-wire — Drive by wire technology in automotive industry replaces the traditional mechanical and hydraulic control systems with electronic control systems using electromechanical actuators and human machine interfaces such as pedal and steering feel… …   Wikipedia

• Multiprocessing — (see also Multiprocessor) Multiprocessing is the use of two or more central processing units (CPUs) within a single computer system. The term also refers to the ability of a system to support more than one processor and/or the ability to allocate …   Wikipedia